Sutron Corporation Satlink Operations & Maintenance Manual, Rev 8.04.2 11/3/2016 pg. 112
During the transmission, you may see the status indicate what the transmitter is doing.
10.6.4. Show Tx Data
Show Tx Data is a great way to confirm that Satlink has been properly setup to transmit your
intended data. The display shows the last transmission and what will be transmitted by the next
transmission. Review the information carefully to make sure that you have the right number of
readings marked for tx and the transmission fits in the specified window.
10.6.5. Send to Sutron
This feature causes Satlink to send an Environmental Satellite transmission on the GOES satellite
using Sutron’s allocated Channel and Satellite ID. The intention is to allow the installer to test
out that a station is working correctly without having to wait for the allocated Scheduled
Transmission time slot.
After requesting a Send To Sutron transmission, check the status of the transmission in the
Telemetry Status window (Telemetry tab) under TX1. Press Refresh to update the status.
To Next Page
Loading...