ENGINE 3-93
OIL JET (for piston cooling and the transmission)
REMOVAL
• The oil jet (for piston cooling and the transmission) can be re-
moved after separating the crankcase.
Remove:
• Oil jet (for piston cooling) 1
• Oil jet (for the transmission) 2
INSPECTION
Make sure that the oil jets are not clogged. If they are clogged,
clean their oil passage using a wire of the proper size and com-
pressed air.
INSTALLATION
Refer to the cylinder block installation, engine reassembly and
engine installation sections.
NOTE:
Before installing the oil jets, apply a light coat of engine oil to the
O-rings.
To Next Page
Loading...
