5-38 CHASSIS
GAS PRESSURE RELEASE
• Mark the drill hole with a center punch.
• Cover the rear shock absorber with a transparent vinyl bag 1.
• Hold the rear shock absorber 2 with a vice.
• Mark a hole with a 3 mm drill.
'
Wear eye protection to protect your eyes from released
gas and metal chips.
10 mm
Mark the
drill hole.
CUSHION LEVER NEEDLE BEARINGS
• Press the needle bearings into the cushion lever using the
special tool.
% 09941-34513: Steering outer race installer
• Apply SUZUKI SUPER GREASE “A” to the spacers and needle
bearings.
For USA
& 99000-25030: SUZUKI SUPER GREASE “A”
For the other countries
& 99000-25010: SUZUKI SUPER GREASE “A”
REAR SHOCK ABSORBER DISPOSAL
'
The rear shock unit contains high-pressure nitrogen gas.
Mishandling can cause explosion.
* Keep away from fire and heat. High gas pressure
caused by heat can cause an explosion.
* Release gas pressure before disposing.
To Next Page
Loading...
