ELECTRICAL SYSTEM 6-31
SIGNAL GENERATOR PEAK VOLTAGE
• Remove the frame cover. (!5-5)
• Remove the side frame cover (left side). (!5-6)
NOTE:
Make sure that all of the couplers are connected properly and the
battery is fully-charged.
• Disconnect the ignitor coupler 1 at the ignitor.
Measure the signal generator peak voltage between the Yel-
low/White and Black/Blue lead wires on the ignitor coupler.
• Connect the multi circuit tester with the peak volt adaptor as
follows.
Black/Blue (+ Probe) – Yellow/White (- Probe)
# 09900-25008: Multi circuit tester set
"
When using the multi circuit tester and peak volt adap-
tor, refer to the appropriate instruction manual.
• Shift the transmission into neutral, turn the ignition switch to
the “ON” position and grasp the clutch lever.
• Press the starter button and allow the engine to crank for a few
seconds, and then measure the signal generator peak voltage.
• Repeat the above procedure a few times and measure the high-
est signal generator peak voltage.
' Tester knob indication: Voltage (
&&
&&
&)
$ Signal generator peak voltage:
More than 1.0 V (Black/Blue – Yellow)
If the peak voltage measured on the ignitor coupler is lower
than the standard value, measure the peak voltage on the sig-
nal generator coupler as follows.
Signal
generator
Signal
generator
coupler
Ignitor
coupler
Peak
volt
adaptor
To Next Page
Loading...
