GSF600Y (2000-MODEL) 8-17
CARBURETOR
ITEM
SPECIFICATION
E-02, 19 E-19 (U-type)
Carburetor type KEIHIN CVR32SS ←
Bore size 32 mm ←
I.D. No. 31F0 31F1
Idle r/min. 1 200 ± 100 r/min. ←
Float height 17.0 ± 1.0 mm
(0.67 ± 0.04 in)
←
Main jet (M.J.) #92 ←
Jet needle (J.N.) N1QL ←
Needle jet (N.J.)
φ
3.4 ←
Throttle valve (Th.V) 11° ←
Pilot jet (P.J.) #35 ←
Pilot screw (P.S.) PRE-SET PRE-SET
(1¾ turns back) (1
7
/
8
turns back)
Throttle cable play 2.0 – 4.0 mm
(pulling cable) (0.08 – 0.16 in)
←
Starter (enricher) plunger cable 0.5 – 1.0 mm
play (0.02 – 0.04 in)
←
ELECTRICAL Unit: mm (in)
ITEM SPECIFICATION NOTE
Ignition timing 13° B.T.D.C. at 1 500 r/min.
Firing order 1•2•4•3
Spark plug
Type
NGK: CR9EK
DENSO: U27ETR
Gap
0.6 – 0.7
(0.024 – 0.028)
Spark performance Over 8 (0.3) at 1 atm.
Pickup coil resistance
Approx. 135 – 200 Ω
Tester range:
(× 100 Ω)
Signal generator peak voltage More than 1.0 V
Ignition coil resistance
Primary
tap – tap Tester range:
Approx. 2 – 4 Ω
(× 1 Ω)
Secondary
Spark plug cap – Spark plug cap Tester range:
Approx. 30 – 40 kΩ (× 1 kΩ)
Ignition coil primary peak
More than 140 V
voltage
Generator Slip ring O.D. Limit: 14.0 (0.55)
Brush length Limit: 4.5 (0.18)
DENSO
Generator maximum output More than 550 W at 5 000 r/min.
Regulated voltage 13.6 – 14.4 V at 5 000 r/min.
Starter relay resistance 3 – 6 Ω
To Next Page
Loading...
