3-4 ENGINE
• Disconnect the PAIR valve hoses 1, 2 and 3.
1 Air cleaner hose
2 Vacuum hose
3 PAIR hoses
• Loosen the respective carburetor clamp screws 4.
• Disconnect the throttle position sensor lead wire coupler 5.
• Slightly move the air cleaner box backward.
• Remove the carburetor assembly by disconnecting the starter
cable 6 and throttle cables 7.
• Remove the wire clamp.
• Disconnect the various lead wires.
8 Gear position switch
9 Signal generator
0 Oil pressure switch
A Speed sensor
B Side-stand switch
To Next Page
Loading...
