3-14 ENGINE
• Remove the cam chain guide 1.
• Remove the cylinder head bolt 2.
• The cylinder head can be removed when its twelve 10-mm nuts
are removed.
NOTE:
When loosening the cylinder head nuts, loosen each nut little by
little, in descending order, according to the numbers cast on the
cylinder head.
• Firmly grip the cylinder head at both ends and lift it straight up.
If the cylinder head does not come off, lightly tap on the finless
portions of it using a plastic mallet.
$
Be careful not to damage the fins when removing or han-
dling the cylinder head.
NOTE:
See page 3-52 for cylinder head servicing.
• Remove the cylinder head gasket 3, O-rings 4 and dowel
pins 5.
To Next Page
Loading...
