ENGINE 3-17
• Remove the starter clutch cover 1.
( 09911-73730: 5 mm “T” type hexagon wrench
• Hold the starter clutch using the special tool and loosen the
clutch spring set bolts in a crisscross pattern. Then, remove
the bolts.
( 09920-34810: Starter clutch holder
• Remove the clutch pressure plate 2, clutch drive plates and
clutch driven plates.
NOTE:
See page 3-68 for the clutch plate inspection.
• Remove the thrust washer 3, clutch release bearing 4 and
clutch push piece 5.
• Draw out the clutch push rods (6 and 7).
To Next Page
Loading...
