3-48 ENGINE
• Install the left and right oil hoses and tighten their mounting
bolts to the specified torque.
$
Replace the O-rings (A and B) with new ones to prevent
oil leakage.
" Oil hose mounting bolt: 10 N
.
m (1.0 kgf
.
m, 7.0 lb-ft)
• Turn the oil filter by hand until you feel that the oil filter gasket
(O-ring) has contacted the oil filter mounting surface. Then,
tighten the oil filter two full turns using the special tool.
( 09915-40610: Oil filter wrench
NOTE:
Before installing the oil filter, apply a light coat of engine oil onto
its O-ring.
• Install the PAIR valve pipes and hoses and tighten their mount-
ing nuts to the specified torque.
$
Replace the gaskets with new ones to prevent exhaust
gas leakage.
" PAIR valve pipe mounting nut:
10 N
.
m (1.0 kgf
.
m, 7.0 lb-ft)
To Next Page
Loading...
