ENGINE 3-61
• Oil each oil seal 1 and press-fit them into position using the
valve guide installer.
• Install each valve spring seat 2 (for intake side) and 3 (for
exhaust side).
" 09916-44310: Valve guide remover/installer
!
Do not reuse the oil seals.
• Insert the valves with their stems coated with molybdenum oil
solution (mixed engine oil/moly paste).
Coat the entire stem making sure that there are no gaps.
!
When inserting each valve, take care not to damage the
lip of the oil seal.
( 99000-25140: SUZUKI MOLY PASTE
• Install the valve springs with the smaller pitch A facing the
cylinder head.
B Larger pitch
C Up
D Paint mark
To Next Page
Loading...
