Suzuki GSF650S - Removal; Inspection and Disassembly

5-8 CHASSIS
REMOVAL
• Remove the brake calipers

1 (LH and RH).
• Loosen the front axle pinch bolt

2.
• Loosen the front axle

3.
• Raise the front wheel off the ground using a jack or wooden
block.
• Draw out the front axle

3 and remove the front wheel.
$
NOTE:
After removing the front wheel, fit the calipers temporarily on
their original positions.
INSPECTION AND DISASSEMBLY
TIRE........................................................... (!2-18, 5-66)
BRAKE DISC............................................. (!5-52)
DUST SEAL
Inspect the dust seal lip for wear or damage. If any damages are
found, replace the dust seal with a new one.
• Remove the spacer

1 (LH) and dust seal (RH).
% 09913-50121: Oil seal remover
$
* Make sure that the motorcycle is supported securely.
* Do not operate the front brake lever with the front
wheel removed.
The removed dust seal must be replaced with a new
one.