ELECTRICAL SYSTEM 6-49
BATTERY
SPECIFICATIONS
a Anode plates
e Stopper
b Separator (fiberglass plate)
f Filter
c Cathode plates
g Terminal
d Upper cover breather
h Safety valve
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape
1 which seals the battery filler
holes
2.
NOTE:
When filling electrolyte, the battery must be removed from the
vehicle and must be put on the level ground.
• Remove the caps
3 from the electrolyte container.
NOTE:
* After filling the electrolyte completely, use the removed cap
3
as sealing caps of battery-filler holes.
* Do not remove or pierce the sealed areas
4 of the electrolyte
container.
• Insert the nozzles of the electrolyte container
5 into the bat-
tery’s electrolyte filler holes. Hold the electrolyte container
firmly so that it does not fall. Do not allow any of the electro-
lyte to spill.
Type designation YTX9-BS
Capacity 12 V, 28.8 kC (8 Ah)/10 HR
Standard electrolyte S.G. 1.320 at 20 °C
To Next Page
Loading...
