CHASSIS 5-51
BRAKE CALIPER REASSEMBLY AND
INSTALLATION
Reassemble and install the brake caliper in the reverse order of
removal and disassembly. Pay attention to the following points:
• Wash the caliper bores and pistons with the specified brake
fluid. Particularly wash the dust seal grooves and piston seal
grooves.
- Specification and classification: DOT 4
$
PISTON SEAL
• Install the piston seals as shown in the illustration.
• Install the piston to the caliper.
1 Dust seal
2 Piston seal
3 Caliper
BRAKE CALIPER HOLDER
• Apply SUZUKI SILICONE GREASE to the caliper holder pins.
. 99000-25100: SUZUKI SILICONE GREASE
* Wash the brake caliper components with new brake
fluid before reassembly.
* Do not wipe the brake fluid off after washing the
components.
* When washing the components, use the specified
brake fluid. Never use different types of fluid or
cleaning solvents such as gasoline, kerosine, etc.
* Replace the piston seals and dust seals with new
ones.
* Apply brake fluid to all of the seals, brake caliper
bores and pistons before reassembly.
To Next Page
Loading...
