ENGINE 3-7
INSTALLATION
Install the engine in the reverse order of engine removal.
• Insert the two long bolts from left side. Install the brackets, spacer, bolts and nuts properly, as shown in
the following illustration.
NOTE:
The engine mounting nuts are self-locking. Once the nuts have been removed, they are no longer of any
use. Be sure to use new nuts and tighten them to the specified torque.
NOTE:
When reusing the removed engine mounting bolts (
1 and
2), apply a small quantity of the THREAD LOCK
to their threads.
" 99000-32110: THREAD LOCK SUPER “1322”
# Frame down tube mounting bolt: 50 N·m (5.0 kgf-m)
LENGTH
Bolt
1 180 mm #
Bolt
2 130 mm ITEM N·m kgf-m
Bolt
3 55 mm
1,
2 75 7.5
Spacer RH
A 27 mm
3 55 5.5
LH
RH
75 N·m
(7.5 kgf-m)
55 N·m
(5.5 kgf-m)
75 N·m
(7.5 kgf-m)
To Next Page
Loading...
