5-16 CHASSIS
• Remove the cylinder
C and rebound spring
D.
• Remove the oil seal by slowly pulling out the inner tube.
NOTE:
Be careful not to damage the inner tube.
$
• Remove the following parts from the inner tube.
E Oil lock piece
F Inner tube slide metal
G Outer tube slide metal
H Oil seal retainer
I Oil seal
INSPECTION
INNER AND OUTER TUBES
Inspect the inner tube sliding surface and outer tube sliding sur-
face for scuffing. If any defects are found, replace them with new
ones.
FORK SPRING
Measure the fork spring free length. If it is shorter than the ser-
vice limit, replace it with a new one.
& Front fork spring free length
Service Limit: 337 mm (GSF650)
332 mm (GSF650S)
The outer and inner tube’s slide metals must be
replaced along with the oil seal and dust seal when
assembling the front fork.
To Next Page
Loading...
