6-18 ELECTRICAL SYSTEM
GENERATOR REASSEMBLY AND
REMOUNTING
Reassemble and remount the generator in the reverse order of
removal and disassembly. Pay attention to the following points:
#
• Apply SUZUKI SUPER GREASE “A” to the lip of the oil seal.
. 99000-25010: SUZUKI SUPER GREASE “A”
• Apply a small quantity of THREAD LOCK “1342” to the bear-
ing retainer screws and tighten them to the specified torque.
/ 99000-32050: THREAD LOCK “1342”
( Bearing retainer screw: 2.5 N·m (0.25 kgf-m)
• Install the bearing and rotor using a hand-press.
1 Hand-press
2 Jig
3 Rotor
4 Bearing
5 Bearing cover #1
6 Bearing cover #2
7 Expander ring
The removed oil seal should be replaced with a new one.
To Next Page
Loading...
