3-8 ENGINE
• Tighten the oil cooler mounting bolts
1 to the specified
torque.
# Oil cooler mounting bolt: 10 N·m (1.0 kgf-m)
• Tighten the oil cooler hose union bolts
2 to the specified
torque.
# Oil cooler hose union bolt: 28 N·m (2.8 kgf-m)
$
NOTE:
When installing new exhaust pipe/muffler assembly connectors,
remove all of the old sealer from the exhaust pipes and from
inside the muffler. Apply the exhaust gas sealer to both the
inside and outside of the new exhaust pipe/muffler assembly
connectors.
EXHAUST GAS SEALER: PREMATEX 1372
• Install the exhaust pipe gaskets
3.
$
• Tighten the exhaust pipe bolts and muffler mounting bolts to
the specified torque.
# Exhaust pipe bolt: 23 N·m (2.3 kgf-m)
Muffler mounting bolt: 23 N·m (2.3 kgf-m)
Use new gasket washers to prevent oil leakage.
Be sure to face the tabs
A on the exhaust pipe gas-
kets
3 to the engine side when installing them.
To Next Page
Loading...
