ELECTRICAL SYSTEM 6-39
• Replace the 180 Ω resister
B with a 5 Ω one
C.
• The fuel level indicator is operating correctly if the LCD bars
increase to five (full) when the ignition switch is turned to ON.
• If either test detects a malfunctioning fuel level indicator,
replace the combination meter unit with a new one.
FUEL LEVEL GAUGE
• Remove the fuel gauge. (!4-7)
• Measure the resistance at each fuel level gauge float position.
If the resistance is incorrect, replace fuel level gauge with a
new one.
The relation between the position of the fuel level gauge float
and resistance is below.
" 09900-25008: Multi circuit tester set
0 Tester knob indication: Resistance (Ω)
SPEEDOMETER
If the speedometer, odometer or tripmeter does not function
properly, inspect the speed sensor and the coupler connections.
If the speed sensor and coupler connections are OK, replace the
combination meter unit with a new one.
SPEED SENSOR
• Remove the seat. (!5-4)
• Disconnect the speed sensor coupler
1.
• Remove the speed sensor
2.
Float position Resistance
A (Full) 3 – 5 Ω
B (Empty) 179 – 185 Ω
82.3˚
13.2˚
To Next Page
Loading...
