3-24 ENGINE
• Remove the C-rings
9 and bearing pins
0.
NOTE:
Do not lose the C-rings and bearing pins.
• Hold the gearshift forks
A and draw out the gearshift fork
shaft
B from the lower crankcase.
• Unhook the gearshift cam stopper spring
C from the lower
crankcase.
• Remove the circlip
D from the gearshift cam, then draw out
the gearshift cam
E from the opposite side.
) 09900-06107: Snap ring pliers
• Remove the circlip
F and gearshift cam stopper
G.
) 09900-06107: Snap ring pliers
NOTE:
Rotate the bearing
H in the crankcase by hand to inspect for
abnormal noise and smooth rotation.
Replace the bearing if there is anything unusual.
) 09900-06106: Snap ring pliers
To Next Page
Loading...
