Engine General Information and Diagnosis: 1A-73
P1651-H (Use of SDS)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Remove the front seat. Refer to “Exterior Parts Removal
and Installation in Section 9D (Page 9D-11)”.
3) Check the TO sensor coupler (1) for loose or poor
contacts.
If OK, then check the TO sensor lead wire continuity.
4) Disconnect the TO sensor coupler.
5) Check the continuity between the R wire and B wire. If
the sound is not heard from the tester, the circuit
condition is OK.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
Go to Step 2. B wire shorted to VCC,
or B/Br wire open.
1
I837H1110050-01
(A)
I823H1110051-01
To Next Page
Loading...
