Engine Electrical Devices: 1C-10
Specifications
Service Data
B837H11307001
FI Sensors
Tightening Torque Specifications
B837H11307002
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-9)”.
Item Standard/Specification Note
CKP sensor resistance 142 – 194 Ω
CKP sensor peak voltage 0.28 V and more When cranking
IAP sensor input voltage 4.5 – 5.5 V
IAP sensor output voltage Approx. 2.7 V at idle speed
TP sensor input voltage 4.5 – 5.5 V
TP sensor output voltage
Closed Approx. 1.1 V
Opened Approx. 4.3 V
ECT sensor input voltage 4.5 – 5.5 V
ECT sensor output voltage 0.15 – 4.85 V
ECT sensor resistance Approx. 2.45 kΩ at 20 °C (68 °F)
IAT sensor input voltage 4.5 – 5.5 V
IAT sensor output voltage 0.15 – 4.85 V
IAT sensor resistance Approx. 2.58 kΩ at 20 °C (68 °F)
AP sensor input voltage 4.5 – 5.5 V
AP sensor output voltage Approx. 3.6 V at 100 kPa (760 mmHg)
TO sensor resistance 16.5 – 22.3 kΩ
TO sensor voltage
Normal 0.4 – 1.4 V
Leaning 3.7 – 4.4 V When leaning 65°
GP switch voltage 0.6 V and more From 1st to Top
Injector voltage Battery voltage
Ignition coil primary peak voltage 80 V and more When cranking
HO2 sensor output voltage
0.4 V and less at idle speed
0.6 V and more at 5 000 r/min
HO2 sensor heater resistance 6.7 – 9.5 Ω at 23 °C (73 °F)
PAIR control solenoid valve
resistance
20 – 24 Ω at 20 – 30 °C (68 – 86 °F)
STP sensor input voltage 4.5 – 5.5 V
STP sensor output voltage
Closed Approx. 0.6 V
Opened Approx. 3.9 V
STVA resistance Approx. 6.5 Ω
EVAP system purge control
solenoid valve resistance
Approx. 32 Ω at 20 °C (68 °F) E-33 only
ISC valve resistance Approx. 80 Ω at 20 °C (68 °F)
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
CMP sensor bolt 10 1.0 7.0 )(Page 1C-3)
TP sensor mounting screw 3.5 0.35 2.5 )(Page 1C-4)
ECT sensor 18 1.8 13.0 )(Page 1C-5)
IAT sensor mounting screw 1.3 0.13 1.0 )(Page 1C-6)
STP sensor mounting screw 3.5 0.35 2.5 )(Page 1C-8)
To Next Page
Loading...
