9B-2 Lighting Systems:
Headlight Removal and Installation
B837H19206002
Removal
1) Remove the body cowlings. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)”.
2) Remove the air intake pipes. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)”.
3) Disconnect the High beam headlight couplers (1),
Low beam headlight coupler (2) and position light
coupler (3).
4) Remove the screws.
5) Remove the intake pipe cover (LH) (4), intake pipe
cover (RH) (5) and intake pipe cover (6).
6) Remove the headlight assembly (7) from body
cowling (8).
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
• After installing, be sure to inspect the headlight beam.
Refer to “Headlight Beam Adjustment (Page 9B-4)”.
Headlight Bulb and Position Light Bulb
Replacement
B837H19206003
CAUTION
!
When you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
1) Remove the combination meter. Refer to
“Combination Meter Removal and Installation in
Section 9C (Page 9C-2)”.
2) Disconnect the headlight (Low beam) coupler (1).
1
1
3
2
I837H1920002-01
I837H1920003-02
4
5
6
I837H1920004-01
“A”: Velcro fastening
7
“A”
“A”
8
I837H1920005-02
1
I837H1920006-01
To Next Page
Loading...
