3A-10 Drive Chain / Drive Train / Drive Shaft:
2) Stake the joint pin by turning (approximately 7/8 turn)
the pressure bolt [A] (3) with the bar until the pin end
diameter becomes the specified dimension.
CAUTION
!
• After joining of the chain has been
completed, check to make sure that the
link is smooth and no abnormal condition
is found.
• Should any abnormal condition be found,
reassemble the chain link using the new
joint parts.
Pin end diameter specification “a”
RK: 5.45 – 5.85 mm (0.215 – 0.230 in)
3) Adjust the drive chain slack, after connecting it.
Refer to “Drive Chain Inspection and Adjustment in
Section 0B (Page 0B-15)”.
Specifications
Service Data
B837H13107001
Drive Train
Unit: mm (in)
Tightening Torque Specifications
B837H13107002
NOTE
The specified tightening torque is also described in the following.
“Drive Chain Related Components (Page 3A-1)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-9)”.
3
I649G1310035-02
“a”
I649G1310036-03
Item Standard Limit
Final reduction ratio 2.687 (43/16) —
Drive chain
Type RK 525SMOZ8 —
Links 114 links —
20-pitch
length
— 319.4 (12.57)
Drive chain slack (on side-stand) 20 – 30 (0.8 – 1.2) —
Gearshift lever height 65 – 75 (2.6 – 3.0) —
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Engine sprocket nut 115 11.5 83.0 )(Page 3A-3)
Speed sensor rotor bolt 25 2.5 18.0 )(Page 3A-3)
Speed sensor bolt 4.5 0.45 3.0 )(Page 3A-3)
Rear sprocket nut 60 6.0 43.0 )(Page 3A-4)
To Next Page
Loading...
