Clutch: 5C-7
17) Remove the clutch lifter drive cam (19) and thrust
washer (20).
18) Remove the spacer (21) and bearing (22).
19) Remove the primary driven gear assembly (23).
NOTE
If it is difficult to remove the primary driven
gear, rotate the crankshaft.
Clutch Installation
B837H15306017
1) Install the primary driven gear assembly (1).
CAUTION
!
• If it is difficult to install the primary driven
gear, rotate the crankshaft.
• Be sure to engage the oil pump drive
sprocket with the primary driven gear.
2) Install the spacer (2) and bearing (3), and apply
engine oil to them.
3) Install the thrust washer (4).
4) Install the seat washer (5).
5) Install the wave spring washers (6) and clutch lifter
driven cam (7).
6) Apply a small quantity of molybdenum oil solution to
the contact surfaces of the clutch sleeve hub, clutch
lifter drive cam and clutch lifter driven cam.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
20
19
I837H1530014-01
22
21
23
I837H1530015-01
1
I837H1530016-03
3
2
I837H1530018-02
4
I837H1530017-02
5
I837H1530019-01
To Next Page
Loading...
