Suzuki GSX-R600 - Page 254

1D-14 Engine Mechanical:
• Apply a thin coat of engine oil to the O-ring, install the
ISC valve to the throttle body and tighten the ISC
valve mounting screw to the specified torque.
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
ISC valve mounting screw (a): 2 N·m (0.2 kgf-m,
1.5 lb-ft)
• With the throttle valves fully closed, install the TP
sensor (2) and tighten the TP sensor mounting screw
to the specified torque.
CAUTION
!
• Apply thin coat of engine oil to the O-ring.
• Align the throttle shaft end “C” with the
groove “D” of the TP sensor.
• Apply grease to the throttle shaft end “C” if
necessary.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
TP sensor mounting screw: 3.5 N·m (0.35 kgf-m,
2.5 lb-ft)
NOTE
• Make sure the throttle valves smoothly
open and close.
• If necessary, adjust the TP sensor. Refer to
“TP Sensor Adjustment in Section 1C
(Page 1C-4)”.
• Apply thin coat of engine oil to the new O-rings (3) and
cushion seals (4).
CAUTION
!
Replace the O-rings and cushion seals with
new ones.
(a)
I837H1140029-01
2
“C”
“D”
I837H1140030-02
I837H1140031-01
3
4
3
4
I837H1140032-01
3
I837H1140033-01