Manual Transmission: 5B-17
• Install the gearshift cam stopper (1), bolt (2), collar (3)
and return spring (4).
• Tighten the gearshift cam stopper bolt (2) to the
specified torque.
NOTE
Hook the return spring end “A” to the
stopper (1).
Tightening torque
Gearshift cam stopper bolt (b): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pin “B” with the
gearshift cam stopper plate hole “C”.
• Apply a small quantity of thread lock to the gearshift
cam stopper plate bolt and tighten it to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (c): 13 N·m (1.3
kgf-m, 9.5 lb-ft)
• Apply a small quantity of thread lock to the gearshift
shaft end screw.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
• When installing the gearshift shaft return spring,
position the stopper “D” of gearshift arm between the
shaft return spring ends “E”.
1
3
4
2
I837H1520053-01
“A”
(b)
2
1
I837H1520054-01
“C”
“B”
5
I837H1520055-01
(c)
I837H1520056-01
I837H1520057-02
“D”
“E”
I837H1520058-01
To Next Page
Loading...
