Suzuki VL125 - Page 103

3-68 ENGINE
• Install the cylinder head cover
NOTE:
* When tightening the cylinder head cover bolts, the piston must
be at top dead center on the compression stroke.
* Install the new gasket washer to the bolts
A .
* Align the cutaway of rocker arm shaft with the bolts
A .
• Tighten the cylinder head cover bolts diagonally, and then if
everything is satisfactory, tighten securely with a torque wrench
to the specified torque.
" Cylinder head cover bolt: 10 N
.
m (1.0 kgf
.
m)
• Check and adjust the valve clearance. (92-4)
• Apply grease to the new O-ring and install the valve inspec-
tion caps.
/ 99000-25010: SUZUKI SUPER GREASE “A”
" Valve inspection cap (EX side): 18 N
.
m (1.8 kgf
.
m)
Valve inspection cap bolt and nut: 10 N
.
m (1.0 kgf
.
m)
• Install the generator cover plug 1 and timing inspection plug
2.
" Generator cover plug: 15 N
.
m (1.5 kgf
.
m)
Timing inspection plug: 21 N
.
m (2.1 kgf
.
m)