5-26 CHASSIS
REASSEMBLY AND REMOUNTING
Perform the reassembly and remounting work in the reverse order of the disassembly and removal proce-
dures while observing the following instructions.
7
* Thoroughly wash all the component parts being assembled.
Insufficient washing can result in oil leakage or premature wear of the parts.
* When reassembling the front fork, use new fork oil.
* Use the specified fork oil for the front fork.
* When reassembling, replace the slide metals, oil seal, dust seal and damper rod bolt gasket
with new ones.
* Use care not to cause damage to the slide metal surfaces since the surfaces are TEFLON coated.
• On the inner tube, assemble the following parts.
1 Dust seal
2 Oil seal stopper ring
3 Oil seal
4 Oil seal retainer
5 Slide metal
6 Guide bushing
7
To prevent the lip of oil seal 3 from being damaged, cover
the inner tube with vinyl sheet A during installation.
• With the oil lock piece 7 fitted to the inner tube so that its taper
side face upward, assemble the inner tube to the outer tube.
To Next Page
Loading...
