ELECTRICAL SYSTEM 6-25
LAMPS
HEADLIGHT AND POSITION LIGHT
HEADLIGHT BULB REPLACEMENT
• Remove the headlight.
• Disconnect the coupler.
• Remove the socket 1.
• Remove the rubber boot 2.
• Remove the bulb 3 by removing the bulb holder spring.
• Remove the position light bulb 4.
• Reassemble the bulb in the reverse order of removal.
&
If you touch the bulb with your bare hands, clean the
bulb with a cloth moistened with alcohol or soapy wa-
ter to prevent premature bulb failure.
Headlight: 12 V 60/55 W (H4)
Position light: 12 V 4 W
.
The headlight uses a halogen bulb which operates at a
high temperature. Therefore, handle the bulb after suf-
ficiently cooled.
&
* A fouled glass can cause damage to the bulb when
lit. If the bulb is contacted with bare hand, wipe clean
with a cloth damped with alcohol or detergent.
* Do not use the bulb of a wattage other than specifi-
cation.
* When installing the rubber boot, turn its “TOP” mark
pointing upward.
To Next Page
Loading...
