ENGINE 3-61
STARTER IDLE GEAR
• Install the starter idle gear 1 and its shaft 2.
OIL SUMP FILTER
• Before installing the oil sump filter, clean it.
NOTE:
* The thinner side of the oil sump filter should be positioned
inside.
* The lip
A
of the oil sump filter should be faced down ward.
GENERATOR COVER
• Install the new gasket and dowel pins 1.
• Apply oil to the each gears, bearing and starter clutch.
• Install the generator cover and tighten the generator cover
bolts.
" Generator cover bolt: 10 N
.
m (1.0 kgf
.
m)
NOTE:
Install the new gasket washer to the bolt
A
.
To Next Page
Loading...
