ENGINE 3-43
PRIMARY DRIVEN GEAR
DISASSEMBLY
• Remove the ring 1 and oil pump drive gear 2.
INSPECTION
Inspect the primary driven gear bearing for any damage. If any
abnormal condition are found, replace the primary driven gear.
REASSEMBLY
• Install the oil pump drive gear with its flanged side A facing
inside.
OIL PUMP
7
Do not attempt to disassemble the oil pump assembly.
This oil pump is available only as an assembly.
INSPECTION
Turn the oil pump shaft and check that rotation is smooth. If any
abnormal condition is found, replace the oil pump with a new
one.
GEARSHIFT SHAFT
Disassemble and reassemble the gearshift shaft as shown in
right picture.
To Next Page
Loading...
