Suzuki VL125 - Cam Chain Guide

ENGINE 3-63
CYLINDER
• Apply sealant to parting line of crankcase.
499000-31110: SUZUKI BOND “1215”
• Place the dowel pins 1 and a new gasket 2 on the crank-
case.
7
Make sure to replace the gasket with a new one.
• Apply the engine oil to the conrod big end, piston and the pis-
ton rings.
CYLINDER HEAD
• Place a new cylinder gasket 1 facing the mark A upward.
7
Make sure to replace the gasket with a new one.
CAM CHAIN GUIDE
• Install the cam chain guide 1 and dowel pins 2.
7
When installing the cam chain guide, check that the
chain is properly engaged with the crankshaft sprocket.
• Coat the cylinder wall with oil.
• Install the cylinder.
NOTE:
Rear (No. 1) cylinder has cam chain tension adjuster hole “F”
side.
Front (No. 2) cylinder has cam chain tension adjuster hole “R”
side.
7
When inserting the piston into the cylinder, use care
not to break the piston ring.
• Install the cylinder head.
F
Rear (No.1)
F
Rear (No.1)
R
Front (No.2)
R
Front (No.2)