3-64 ENGINE
• Apply the engine oil to the copper washers.
• Install the copper washer and cylinder head nuts.
• Tighten the cylinder head nuts diagonally and evenly.
• The nuts tightening must be performed in two stages; initial
and final tightening.
" Cylinder head nut: 25 N
.
m (2.5 kgf
.
m)
• Install the front piston, cylinder and cylinder head in the same
manner of rear ones installation.
• Apply the THREAD LOCK to the bolts and tighten them.
-99000-32050: THREAD LOCK “1342”
INTAKE PIPE
• Fit the intake pipe as shown in right picture.
To Next Page
Loading...
