ENGINE 3-45
REASSEMBLY
Assemble the countershaft and driveshaft in the reverse order
of disassembly. Pay attention to following points:
NOTE:
Always use new circlips.
NOTE:
Before installing the gears, coat lightly engine oil to the driveshaft
and countershaft.
7
* Never reuse a circlip. After a circlip has been removed
from a shaft, it should be discarded and a new circlip
must be installed.
* When installing a new circlip, care must be taken not
to expand the end gap larger than required to slip
the circlip over the shaft.
* After installing a circlip, always ensure that it is com-
pletely seated in its groove and securely fitted.
• When installing a new circlip, pay attention to the direction of
the circlip. Fit it to the side where the thrust is as shown in
figure.
TRANSMISSION GEARS AND RELATED PARTS
To Next Page
Loading...
