Svantek SV 104A User Manual

SV 104A USER'S MANUAL_______________________________________________________
57
6.5.2 Profile settings tab
The main settings where specific acoustic profile configuration can be set are located under “Dosimeter”
tab. There are already predefined pre-sets in each profile column. By choosing predefined configuration some
obvious fields will be automatically greyed. Others must be setup by the user.
There are three additional user-defined pre-sets, whose name can be changed during configuration with
use of the little icon (notes with a pen) which is then enabled.
Apart from alarm DOSE threshold there are three additional source of warning alarm, which can be set.
See figure below.
Figure 6-8 Dosimeter settings - profile configuration tab
Note: Note, that some profiles can be disabled to be seen later during measurement run (see
chapter 6.5.5)
change user
defined preset
name
change additional
source of alarm

Svantek SV 104A Specifications

General

Brand	Svantek
Model	SV 104A
Category	Measuring Instruments
Language	English