Svantek SV 104A User Manual

SV 104A USER'S MANUAL_______________________________________________________
60
6.5.5 Display VIEW configuration tab
As mentioned in chapter 3.9 there are quite a few VIEW modes accessible on the display, when
the dosimeter is performing a measurement run.
• In the left panel named “Modes views” you can select which VIEW mode will be present when
you press the <ENTER> key on the dosimeter keypad
Note: If you do not want to use all three ACOUSTIC PROFILES it would be convenient
for you to enable only one acoustic PROFILE to be displayed – just select the required one.
Note: The “ONE-RESULT” (chapter 3.9.2) is the only VIEW mode that is always
present, and cannot be disabled.
• In the right panel named “Display Results”, you will find a list of over a dozen
measurement parameters, that can be configured to be presented on the SV 104A display,
when you press <SCROLL> key. See Appendix D to review acronyms for each parameter.
Figure 6-11 Display VIEW configuration tab
Up to three
profiles can be
switched on
Screen saving
mode can be
activated

Svantek SV 104A Specifications

General

Brand	Svantek
Model	SV 104A
Category	Measuring Instruments
Language	English