Svantek SV 104A - Figure 4-4 Unit Label Screens; Figure 4-5 Load Setup Menu; Figure 4-6 Load Setup Confirmation; Measurement Setup - Basic Configuration

SV 104A USER'S MANUAL_______________________________________________________
33
The following screen will be presented:
Figure 4-4 Unit label screens
Unit label screen is moved with <SCROLL> , <PROFILE> keys.
To exit the Unit Label screen just shortly press the <ENTER> key. Then SV 104A will return to the
last presented VIEW mode.
Note: The personalized Unit Name can be set arbitrarily with Supervisor software.
4.6 Measurement setup - basic configuration
Press two keys <SCROLL> and <ENTER> at the same time. The “Load Setup” menu will
appear with the list of loaded configuration setups to choose.
Figure 4-5 Load setup menu
To abandon setup selection, press again the <SCROLL> and <ENTER> at the same time.
Otherwise select the required configuration setup with <ENTER> key navigating thru the list with
<SCROLL> or <PROFILE> key.
The following screen will appear, that will allow you to confirm you really want to load the selected setup
or cancel the selection and return to configuration setup list:
Figure 4-6 Load setup confirmation
UNIT NAME
user programmable
serial number
firmware
version
standards
conformity