To this chapter contents
2. Maintenance Information
Lubrication System
2-3
Engine oil quantity
Caution
z Turn off engine, and park the
motorcycle in flat surface with main
stand.
z Check oil level with oil dipstick. (Do not
screw the dipstick into engine when
checking.)
If oil level is near lower limit, fill in the
recommended engine oil to upper limit.
Exchange the engine oil
Engine off and disassemble the oil dipstick.
Remove the oil drain bolt under the crankcase
to drain the engine oil.
After completely drain the engine oil, clean the
drain bolt and the washer. If the washer is
deformed or cracked, please change a new
one
Engine oil drain bolt torque：3.5~4.5kgf-m
Caution:
Fill in the engine oil to the standard quantity.
Add oil to crankcase (oil viscosity SAE
10W-30) Recommended using Bramax series
engine oil.
Engine oil exchange volume
Full disassembly：1200 c.c.
Regular exchange：1000c.c.
Install the dipstick, run the engine for several
minutes.
Turn off the engine, and check oil level again.
Check if engine oil leaks.
z Warm up the engine before drain oil, that
will make engine oil easily drained
thoroughly
Oil drain bolt
To Next Page
Loading...
