To this chapter contents
4
、
Lubrication / Clutch / Transmission
Clutch plate inspection
4-14
Use a feeler gauge to measure the warp of
each clutch plate.
Service limit：under 0.2mm
Clutch outer inspection
Check the clutch outer to see if any cracks or
damage can be found.
Clutch Installation
Install the clutch outer and the 20mm washer.
Caution
z You can slightly rotate or sway the 20mm
washer to make it fit into the main shaft
groove.
Install the clutch pressing plate, friction disks,
clutch plates, and the clutch center. Then
install the 20mm holding ring.
Washer
Holding Ring
To Next Page
Loading...
