To this chapter contents
4
、
Lubrication / Clutch / Transmission
Turn the 20mm washer to match the indent on
the main shaft with that on the washer.
Remove the washer and disassemble the
clutch outer
4-13
Disassemble the clutch center, clutch plates,
clutch friction disks, and the pressing plate.
Clutch Inspection
Clutch spring inspection
Measure the free length of the four clutch
springs.
Service limit：Above 32.4mm
Clutch friction disk inspection
Measure the thickness of each clutch friction
disk. If it’s under service limit or it’s damaged,
please replace with a new one.
Service Limit：Above 2.5mm
20mm Washer
Clutch center
Clutch
ressin
late
Clutch plate
Friction disk
To Next Page
Loading...
