To this chapter contents
5. AC Generator / Starter Clutch
5-5
ACG stator inspection
Check the following circuit for electricity
conductivity.
Yellow ~ Pink 0.9Ω±10%
Black/White ~ Grounding 420Ω±10%
Green/White ~ Blue/White 105Ω±10%
Light Green/ Red (for the neutral gear sensor)
ACG Stator assembly
Assemble the ACG stator holding screws.
(Screw×2)。
Assemble the stator wire correctly onto the
L-crankcase cover with the rubber seal.
Insert the dowel pin, set the L crankcase cover
gasket to the correct position.
Assemble the L crankcase cover (Bolt×9).
Green/White
Yellow
Rubber seal
Light Green/ Red
Black/ red
Blue/White
Pink
Bolt×9
To Next Page
Loading...
