13. Cooling System
13-8
Replacement of Mechanical Seal
Drive the mechanical seal and inner seal out of
the right crankcase.
Tools required
Water pump bearing driver
Caution
Replace a new mechanical seal after removing
it.
Install the new inner seal onto the right
crankcase.
Tools required
Water pump mechanical seal driver
Apply a coat of sealant to the mating surfaces of
the right crankcase before installing the new oil
seal.
Install the mechanical seal onto the right
crankcase.
Tools required
Water pump mechanical seal driver
Install a new outside bearing to the right
crankcase cover.
Tool required
Water pump bearing (6901) driver
Caution
Do not reuse old bearing. It must be replaced
with a new one once it has been removed.
bearing driver
To this chapter contents
To Next Page
Loading...
Need help?
General
