Symbol DIGITAL DS6708 - Appendix A Standard Default Parameters

Appendix A Standard Default Parameters
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults 4-4
Parameter Scanning ECh Enable 4-5
Beeper Tone 91h Medium 4-6
Beeper Volume 8Ch High 4-6
Power Mode 80h Continuous On 4-7
Time Delay to Low Power Mode 92h 1 Minute 4-8
Trigger Mode 8Ah Auto Aim 4-9
Picklist Mode F0h 92h Disabled Always 4-10
Presentation Mode F1h, 74h 3 Sec 4-11
Decode Session Timeout 88h 9.9 Sec 4-13
Timeout Between Decodes, Same Symbol 89h 0.6 Sec 4-13
Beep After Good Decode 38h Enable 4-14
Fuzzy 1D Processing F1h, 02h Enable 4-14
Decode Mirror Images F1h, 19h Never 4-15
1
User selection is required to configure this interface and this is the most common selection.