Symbol DIGITAL DS6708 - Page 405

Standard Default Parameters A - 3
RS-232 Host Parameters
RS-232 Host Types Standard
1
7-7
Baud Rate 9600 7-8
Parity Type None 7-10
Stop Bit Select 1 Stop Bit 7-11
Data Bits 8-Bit 7-11
Check Receive Errors Enable 7-12
Hardware Handshaking None 7-12
Software Handshaking None 7-14
Host Serial Response Time-out 2 Sec 7-16
RTS Line State Low RTS 7-17
Beep on <BEL> Disable 7-17
Intercharacter Delay 0 msec 7-18
Nixdorf Beep/LED Options Normal Operation 7-19
Ignore Unknown Characters Send Bar Code 7-19
IBM 468X/469X Host Parameters
Port Address None Selected 8-4
Convert Unknown to Code 39 Disable 8-5
Wand Emulation Host Parameters
Wand Emulation Host Types Symbol OmniLink Interface
Controller
1
9-5
Leading Margin 80 msec 9-6
Polarity Bar High/Margin Low 9-7
Ignore Unknown Characters Ignore 9-7
Convert All Bar Codes to Code 39 Disable 9-8
Convert Code 39 to Full ASCII Disable 9-9
Table A-1 Standard Default Parameters Table (Continued)
Parameter
Parameter
Number
Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.