Tasks
The following tasks show methods by using the front panel and the command line interfaces. In many
cases the task cannot be performed by the front panel interface, in which case a "Not applicable" des-
ignator is given.
See also:
l Front Panel Controls and Indicators
l Command Line Interface
For the command line interface entries below, it is assumed in the following tasks that you are
presently in the command line interface menu.
How to Get or Set the Input Impedance
The choices here are 50 Ω and 1000 Ω.
Front Panel Command Line Interface
Not applicable
To set impedance value enter:
impedance [<50|1000>] <CR>
To get impedance value enter:
impedance<CR>
9611B_UserGuide_RevA.pdf.......................................................................... Page 25
To Next Page
Loading...
Need help?
General