Status
Status
l Senses signal presence on all inputs and outputs
l Green/Red LEDs on front panel
l Relay contact close on rear panel
l RS-232 interface for monitor and control
EMC
The system has been tested and passed the following Electromagnetic Compatibility Standards that
are required for CEMark.
Radiated Emissions, 30 MHz – 1 GHz EN55022, Class A
Conducted Emissions, 150 kHz – 30 MHz EN55022, Class A
Immunity Characteristics EN55024, Class A
Electrostatic Discharge EN61000-4-2
Radiated RF Immunity EN61000-4-3
Electrical Fast Transient / Burst EN61000-4-4
Surge Immunity EN61000-4-5
Conducted RF Immunity EN61000-4-6
Power Frequency H-Field Immunity EN61000-4-8
Voltage Dips and Interruptions EN61000-4-11
AC Harmonic Emissions EN61000-3-2
AC Short and Long Term Flicker EN61000-3-3
FCC Certification
The system has been tested and passed the following FCC Part 15 emissions requirements for Class
A performance.
Radiated Emissions 30 MHz – 1 GHz
Conducted Emissions 150 kHz – 30 MHz
FCC Class A Radiated and Conducted Emissions (see following notes).
Note: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
Page 40 ..........................................................................9611B_UserGuide_RevA.pdf
To Next Page
Loading...
Need help?
General