20 S100 User Guide – Rev. D – June 2005
SyncServer S100
Making All Connections: An Overview
Use your standard PC workstation to configure the S100.
Refer to the illustrations in this section when you install the S100.
You will need to make a network connection (you may or may not require a hub to do this). It
is suggested you obtain an IP address from your IT department. The Serial cord connects the
S100 to your computer. Connect the S100 to your network using the network port. Use your
verified IP address in your web browser to reach the S100’s Configuration Wizard online.
To Next Page
Loading...
