S100 User Guide – Rev. D – June 2005 51
2
5
3
8. The IP is added to the Active Servers window. Click OK. The IP address is listed under
Active Servers.
To Synchronize SymmTime:
1. Right-click anywhere on the clocks. Select Sync Status from the menu to tell your
computer to automatically get time from the S100. A similar screen will appear.
2. Click Sync Now. If you receive a no response, it is because you have not yet configured
the S100; configure it now. An affirmative response confirms you have configured the
S100.
Next: Use the Web-Based Interface
Now that you have established the S100, configured your time source, and installed your
client software, you can use the web-based interface to manage S100 operations. See
Chapter 4 for a complete description.
To Next Page
Loading...
Need help?
General
