74 S100 User Guide – Rev. D – June 2005
SyncServer S100
ifconfig Output
This screen gives you information about the network configuration of the S100. It lets you
troubleshoot network problems.
Ping
Use the ping command to test the network route between the S100 and a remote host.
This is a diagnostic tool that confirms that all is well between the two devices.
The dialog shown in Figure 4-24 lets you define the following parameters:
Host - URL of the remote host
Figure 4-23: Configuration Information
Figure 4-24: Pinging the Remote Host
To Next Page
Loading...
Need help?
General
