80 S100 User Guide – Rev. D – June 2005
SyncServer S100
Alarms
This page lets you configure alarm activity
.
E-mail Address - This e-mail address is where any alarm messages will be sent.
Mail forwarder - The server that will handle the e-mail.
Issue Alarms - Here, check when you want alarms sent:
• Upon boot, and if Flywheeling continues for more than 60 seconds. If you check here
for this alarm, it will tell you that the system has lost contact with its source of time but
will keep going for some period.
• If there has been a Configuration Change, you can check here for an alarm to be
sent.
Reset lets you clear the entered data, and Submit tells the system you are finished.
Configuration Wizard
The next item on the Admin menu is the Configuration Wizard. This helps you select and
configure your time reference.
Step-by-step Configuration Wizard instructions are in “The Configuration Wizard” on
page 32.
Figure 4-33: Setting Alarm Parameters
To Next Page
Loading...
Need help?
General
